An Implementation Engineer is upgrading Purity on a controller. As puresetup user, which command should be used to list the device path of the USB drive?

During an NDU, the new controllers arrive with an older version of Purity than what is currently installed on the array. What action should the Implementation Engineer take to install the correct version of Purity on the new controllers?

An Implementation Engineer has completed cabling a DirectFlash Shelf (DFS) to the FlashArray. Which command should the Implementation Engineer run to verify that the cabling was completed correctly?

How many rack units are required to install a FlashArray//XL with one DirectFlash Shelf?

An Implementation Engineer runs puresetup newarray on a new FlashArray with a 63TB data pack in the chassis and the flow fails with “Unable to create an Apartment” error message. What is the most likely root cause?

When adding a data pack into a FlashArray chassis or a DFS shelf, the drives show “unrecognized” status when running puredrive list.    What is the cause of this status on the newly inserted drives?

What is the minimum AC voltage required to operate a FlashArray//X20R4 array?

Which PCIe slot must be used for a SAS HBA on R4B revision controllers?

Refer to the exhibit. During the puresetup portion of the new controller setup of an NDU, the Implementation Engineer gets the error message shown in the exhibit. What action should the Implementation Engineer take next?

An Implementation Engineer is performing a FlashArray//XR4 to FlashArray//XL upgrade, and is preparing to remove the XR4 CT0 controller.Which command should the Implementation Engineer run to stop Purity after confirming CT0 is the secondary controller?